Stainless steel plate with vertical outer feature for power supply

The stainless steel plate is welded with a power source stainless steel pipe with vertical characteristics. The development of steel pipe technology and production technology began with the rise of the bicycle manufacturing industry. The development of oil in the early 19th century, the manufacture of ships, steam boilers and aircraft during the two world wars, the manufacture of thermal electric steam boilers after the second world war, the development of the chemical industry, and the drilling, production and transportation of oil and natural gas, etc. All of them have strongly spurred the growth of the steel industry in terms of variety, output and quality.  1. Use a power supply with vertical outer characteristics, and use positive and negative (the wire is connected to the negative and) when DC. 2. Generally suitable for the welding of thin steel pipes below 6mm, it has the characteristics of beautiful welding seam forming and small welding deformation.  3. The shelter gas is argon with a purity of 99.99%. When the welding current is 50~50A, the argon flow rate is 8~0L/min, and when the current is 50~250A, the argon gas flow rate is 2~5L/min. 4. The length of the tungsten and the protrusion from the gas nozzle is preferably 4~5mm. It is 2~3mm in places with poor masking such as fillet welding, and 5~6mm in places with deep grooves. The distance from the nozzle to the working is normal. not over 5mm.  5. In order to prevent the appearance of welding pores, if there is rust or oil stains on the welding part, be sure to clean it up. 6. Welding arc length, when welding ordinary steel, it is better to use 2~4mm, and when welding stainless steel, it is better to be ~3mm, if it is too long, the protection effect is not good.   7. In order to prevent the backside of the bottom bead from being oxidized during butt priming, the backside also needs to be protected by gas. 8. In order to make the argon gas well protect the welding pool and facilitate the welding operation, the tungsten and the intermediate line and the workpiece at the welding place should generally be connected at an angle of 80~85°, and the angle between the filler wire and the surface of the workpiece should be as small as possible. Usually around 0°. 9. Windproof and ventilation. In windy places, be sure to take the method of blocking the net, and take appropriate ventilation methods indoors.
There are a lot of businesses today that are very much in demand and one of them is a architectural metalwork.
We are an experienced supplier of and have gained good reputaion among global customers. With a wide range of in offer, we can customize according to your requirement. Send us your enquiry at Topson Stainless Steel Decorative Sheets&Metal Fabrication Works.
Foshan Topson Stainless Steel Co., Ltd. deems that we can drive consumer transactions using high-tech tools like artificial intelligence and cognitive data sets.
To properly understand what customers want, when, why and how they want it, Foshan Topson Stainless Steel Co., Ltd. needs to pivot toward sentiment analysis, a burgeoning technology that taps into consumer demand based on natural language processing.
architectural metalwork also offers several other architectural metal fabrication that could potentially be useful for manufacturers.