How is the deep drawing process of stainless steel honeycomb panel made?

How is the deep drawing process of stainless steel honeycomb panels made? Stainless steel honeycomb panel manufacturers answer:

Construction preparation → lofting → blanking → welding installation → grinding → weld inspection → grinding

(1) Stake out the site before construction and calculate the length of each component.

(2) According to the length of the protective net, the blanking length of the component is allowed to be 1mm.

(3) Select the appropriate welding process, electrode diameter, welding current, welding speed, etc., and verify through the welding process test.

(4) Degreasing and decontamination treatment: Before welding, check whether the groove and assembly gap meet the requirements, whether the tack welding is firm, and there must be no oil around the welding seam. Otherwise, use trichloroethylene, benzene, gasoline, neutral detergent or other chemicals to scrub with a stainless steel wire fine brush. If necessary, grind the metal surface with an angle grinder before welding.

(5) When welding, a thinner stainless steel electrode (welding wire) and a smaller welding current should be used. There shall be no uniform welding slag, burr and other defects on the surface of the welding seam, and there shall be no defects such as welding joints and burrs.

(6) After the welding and assembly of the rods, the welds without obvious dents or large protruding welds can be directly ground. For welds with concave-convex scum or large bead, grind with an angle grinder, and grind after grinding. After grinding, the appearance must be smooth with no visible welding marks.